1. First check whether the screws of each part of the pellet machine are tightened, then loosen the two adjustment screws at both ends of the pressure roller, and then start the motor to carefully check whether there is any bad phenomenon when the pellet machine rotates.

2. If there is no problem, then tighten the two pressure wheel adjustment screws, and then start the machine. The next step is to put the materials to be ground one after another, and repeat the grinding several times until the template holes are smooth and all the materials are discharged.

3. The pellet machine must stop feeding before shutting down, wait for the material in the silo to be processed, and then add some oily material into the template hole, so as to keep the hole lubricated and ensure that it will not appear in the next use. blockage.

When using the pellet machine, overload production must be prohibited, because overload will have a certain impact on the direct deceleration of the pellet machine and the motor, so this must be avoided. If it occurs, repair and replaces the damaged parts immediately.